Medtronic Guardian Link 3 Manual Del Usario página 13

6 Attach the adhesive tab of the sensor to the
transmitter.
7 Refer to the sensor user guide for instructions on how
to apply a second tape.
8 Follow the instructions that appear on the pump
screen or in your system user guide.
Disconnecting the transmitter from the
sensor
Before proceeding, have your system user guide available.
To disconnect the transmitter from the sensor:
1 Carefully remove any tape from the transmitter and sensor.
2 Remove the adhesive tab from the top of the transmitter.
3 Hold the transmitter as shown, and pinch the flexible side
arms of the sensor between your thumb and forefinger.
4 Gently pull the transmitter away from the sensor.
5 Follow the instructions that appear on the pump or in your
system user guide.
Removing the sensor
Always refer to the sensor user guide for instructions on how to remove the sensor.
Bathing and swimming
After the transmitter and sensor are connected, they form a waterproof seal to a
depth of 2.4 meters (8 feet) for up to 30 minutes. You can shower and swim without
removing them.
Tester
The tester is used to test the transmitter to make sure the transmitter is working. The
tester is also used as a required component for cleaning the transmitter. Properly
connecting the tester to the transmitter ensures that fluids do not come in contact
with the connector pins inside the transmitter. Fluids can cause the connector pins to
corrode and affect the performance of the transmitter.
Do not twist the tester while it is attached to the transmitter. This will damage the
transmitter.
-7-