Medtronic Guardian Link 3 Manual Del Usario página 12

Ocultar thumbs Ver también para Guardian Link 3:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 103
3
When charging is complete, the green light on the charger will
stay on, without flashing, for 15 to 20 seconds and then turn off.
4
After the green charger light turns off, disconnect the
transmitter from the charger. The green light on the transmitter
will flash 10 times and then turn off.
Pairing your transmitter
Always refer to the system user guide for instructions on how to
pair your transmitter to your pump.
Inserting the sensor
Always refer to your sensor user guide for instructions on how to insert the sensor.
Connecting the transmitter to the sensor
Before proceeding, have your system user guide available.
To connect the transmitter to the sensor:
1
After the sensor is inserted, consult your sensor user guide for details on applying the
required tape before connecting the transmitter.
2
Hold the rounded end of the inserted sensor to prevent the sensor from moving
during connection.
3
Hold the transmitter as shown. Line up the two notches on the
transmitter with the side arms of the sensor. The flat side of the
transmitter should face the skin.
4
Slide the transmitter onto the sensor connector until the sensor
arms snap into the notches on the transmitter. If the transmitter
is properly connected, and if the sensor has had enough time to
become hydrated, the green light on the transmitter will flash 6
times.
Note: If the transmitter does not flash, see Troubleshooting, on page 19.
5
When the transmitter light flashes green after connecting to the sensor, use your
pump to start the sensor. For more instructions, see your system user guide.
-6-
Tabla de contenido

Solución de problemas

loading

Tabla de contenido