STOK Tower Manual Del Operador página 11

STEP 3: ASSEMBLING ThE WhEELS TO ThE
LEGS
See Figure 9.
Remove the following hardware from the blister pack:
EE - 2 Cotter Pins
ff - 2 Flat washers -10 mm
GG - 2 Axles
 Insert an axle (GG) through each wheel. Slide a washer
(ff) over each axle.
 Insert an axle through each rear leg.
 Insert a cotter pin (EE) through the hole in each axle as
shown.
CAUTION:
Do not overtighten screws when attaching handles.
Overtightening screws could damage the firebox.
STEP 4: ATTAChING fIREBOX hANdLE
See Figure 10.
 Turn the grill over and set it upright.
Remove the following hardware from the blister pack:
MM - 4 Round head screws
 Insert round head screws (MM) through the holes in the
handle.
 Securely tighten the screws to the firebox.
STEP 5: ASSEMBLING ThE ASh CANISTER
See Figure 11.
Remove the following hardware from the blister pack:
AA - 2 Nyloc nuts
BB - 2 Spacers
 Hold the ash canister handle as shown.
 Insert the threaded studs on the handle through the holes
in the heat shield.
 Place the spacers (BB) over the studs.
 Insert the studs through the holes in the ash canister.
 Slide the nyloc nuts (AA) over the studs and tighten with
an adjustable wrench.
ASSEMBLY
Fig. 9
FIREbOX
hANdLE
scREW
Fig. 10
NuTs
Ash
cANIsTER
Fig. 11
11
WAshER
WhEEL
AXLE
cOTTER pIN
spAcERs
sTuds
hEAT shIELd
hANdLE