STOK Tower Manual Del Operador página 10

STEP 2: ASSEMBLING ThE LEGS ANd BASE
TO ThE STANd
See Figures 7 - 8.
Remove the following from the blister pack:
hh - 4 Bolts (M6 x 55)
II
- 9 Flat washers (6 mm)
JJ - 9 Lock washers (6 mm)
KK - 9 Hex nuts (M6)
LL - 3 Bolts (M6 x 16)
NN - 2 Bolts (M6 x 62)
 There are two U-shaped leg sections.The legs that angle
outward are for the front of the grill. The straight legs are
for the back of the grill.
 Make sure the rear leg section is placed with the dimple
facing up.
 Set the legs onto the base.
 Insert four (4) bolts (hh) through the base, leg sections,
and brace as shown.
 Slide a washer (II), lock washer (JJ), and nut (KK) over
each bolt and finger-tighten.
To attach the assembled base, legs, and brace to the
supports:
 Align the side panel tabs with the slots in the base.
bRAcE
LEg sEcTION
(FRONT)
sLOT FOR
sIdE pANEL TAb
bAsE
(bOLT - hh)
Fig. 7
ASSEMBLY
 Insert two (2) bolts (LL) through the two rounded tabs and
 Slide a washer (II), lock washer (JJ), and nut (KK) over
 Insert two (2) bolts (NN) through the rear support tabs,
 Slide a washer (II), lock washer (JJ), and nut (KK) over
 Using an adjustable wrench, securely tighten all bolts.
NuT
LOck WAshER
WAshER
LEg sEcTION
(REAR)
dImpLE
Fig. 8
10
one (1) bolt (LL) through the front support and base.
each bolt and finger-tighten.
base, rear legs and brace.
each bolt.
ROuNdEd TAb
(FOR bOLTs - LL)
REAR suppORT
TAb (FOR bOLTs - NN)
LEgs
bAsE
FRONT
suppORT
bOLT
(TWO - NN)
sIdE pANEL TAb
(INsERT INTO bAsE)
NuT
LOck
WAshER
WAshER
REAR
suppORT
TAb
bOLT
(ThREE - LL)