Installation - TECshow RAZOR 7R BEAM Manual De Usuario

2. Installation

Unpacking the fixture (for flight case pack only)
1. Stop the flight case via the brake sheet above the wheels.
2. Unlock the lock modules (1) and open the cover board.
3. Prop the cover board with lid bracket.
4. Take out the fixture.
5. Unlock the lock module (2) take out omega clamps.
Installation:
1. Bolt each clamp (1) to the Omega holder with screw and
lock nut through the hole in the holder.
2. Fasten the omega holders (2) on the bottom of the base by
inserting quick-lock fasteners (3) into the holes of the base
and tighten fully clockwise.
3. Hang the fixture to the support (4) through clamp and fas-
ten the screws (5). Fasten the safety cable (6) through the
bottom of the base and over the support.
Attention:
Always ensure that the structure to which you are attaching
the unit is secure and is able to support a weight of 10 times
of the unit's weight without any harming deformation.
• Also always use a safety cable that can hold 12 times of
the weight of the unit when installing the fixture.
• Make absolute sure that the unit is firmly fixed in way that
no vibrating or slipping would occur during operation.
• The equipment must be installed beyond the areas
where persons may walk by or be seated.
• The rigging has to be operated by or under the guide of
a skilled person.
RAZOR 7R BEAM
ENGLISH VERSION
Fig. 1 Fig. 2
p. 4