Gobo-Wheel And Lamp; Gobo-Wheel; Lamp; Change The Lamp - TECshow RAZOR 7R BEAM Manual De Usuario

5. Gobo-wheel and Lamp

5.1 Gobo-wheel

DANGER!
Install/change the gobo-wheel with the device
switched off only.

5.2 Lamp

Philips MSD Platinum 5R (8000K)
• Because of its high internal pressure, there might be a
risk that the Discharge lamp would explode during op-
eration. The lamp emits intense UV radiation which is
harmful to the eyes and skin. The high luminance of the
arc can cause severe damage to the retina if you take a
close look at the lamp.
• To protect the lamp, always turn off the lamp first (via con-
trol panel or DMX controller) and let the unit run at least
five minutes to cool down before switching off the mains
supply. Never handle the lamp or luminary when it is hot.
• Do not touch the bulb with bare hands. If this happens,
clean the lamp with denatured alcohol and wipe it with
a lint free cloth before installation.
• The lamp generates UV radiation. Never operate the
lamp without appropriate shielding.
• When lighting up, the lamp operates at high pressure
and there is a slight risk of arc tube rupture. The risk in-
creases with age, temperature and improper handling of
the lamp. Do not use the lamp longer than its lifespan.
• Make sure the lamp is located in the center of the reflec-
tor for the best projection
RAZOR 7R BEAM
ENGLISH VERSION

5.3 Change the Lamp

Fig. 1
1. FollowtheFig.1andFig.2: Loosen the four screws and open-
thecover
Fig. 3
2. Follow the Fig.3 and Fig.4: Loosen the two screws and
apart the entire assembly
Fig. 5
3. Follow the Fig.5 and Fig.6: Unplug all the connect wires
over the lamp and wear Anti-static gloves to take on the lamp
4. Change a new lamp
Fig. 2
Fig. 4
Fig. 6
p. 8