Installation - Tecno-gaz MULTISTERIL 2200S Manual Del Usuario

ENGLISH

INSTALLATION

Remove the packing and inspect the cleaner.
If you notice any signs of damage, contact the manufacturer.
Keep the packing material available for the entire duration of the warranty
period. The manufacturer will not accept goods returned without the original
packing.
Place the cleaner on a flat, stable surface.
When drying, the cleaner releases hot air from the sides and intakes air from
the back, so leave at least 5 cm of free space on the sides and the back of the
cleaner during installation.
Do not install the cleaner in potentially explosive atmospheres.
Install the cleaner far from sources of heat (e.g., bunsen burners, steamers,
ovens, etc.).
Install the cleaner so that the control panel and the screen can be clearly seen
by the user.
Make sure the power cable is not damaged.
Transportation and handling should be carried out applying the precautions normally
used for fragile goods.
The adjustable feet make it possible to tilt the cleaner
to facilitate draining the tank.
When first installed, put some water in the tank and
make sure it drains rapidly.
DO NOT TILT THE TANK TOO MUCH
Connecting and commissioning the cleaner:
Connect the power cable to the socket on the back of the cleaner (Pct. 3).
Make sure the supply voltage corresponds to the voltage shown on the
nameplate.
Make sure the electrical system is provided with an efficient
The machine is switched on and off by a double‐pole switch located above the power
socket.
Positioning the tank:
Electrical connections
12
.