Operation - Unold 86436 Instrucciones De Uso

OPERATION

1. Comply with all safety instructions and safety regulations.
2. Ensure that you have selected a safe location.
3. Plug the mains plug of the appliance into an electrical outlet (220-240 V ~
50 Hz).
4. Press the ON/OFF button
5. Caution: The following explanations apply for adjustment on the control
panel itself, and via the remote control unit. The button designation is iden-
tical in each case.
Heating capacity
6. You can select from two heating capacities:
ƒ "Low" level for low capacity
ƒ "High" level for high capacity
7. Note: It takes a few moments until the higher capacity is completely active.
8. Use the
lamp shows the level at which the appliance is operating.
9. The appliance heats until the desired temperature is reached, then the
appliance switches off. The appliance will switch on again as soon as the
room temperature drops below the set temperature.
Oscillation function / swing function
10. With this function it is possible to distribute the air flow over a larger area,
because the appliance swings back and forth in a specific radius.
11. The oscillation function can be switched on in every mode. To do this, select
the button. If you want to stop the appliance in a specific position,
press the
12. Switch off the oscillation function before you switch off the appliance.
Timer
13. Via the Timer button
This is possible in the range 1 to 8 hours in increments of 60 minutes. Press
the „Timer" button until the selected time is illuminated. After this time
elapses the appliance switches off automatically. If you do not make a time
setting, the appliance will run continuously.
Selecting the temperature
14. Use the "+" and "-" buttons on the remote control to select the desired
temperature in a range between 4 and 32°C.
button to select the desired capacity. The respective indicator
button again.
you can select the desired runtime of the appliance.
. A short signal tone will sound.
(approx. 750-900 watt)
(approx. 1,500 watt)
25