Original Accessories/Auxiliary Equipment; Operation; Fitting/Changing The Saw Blade; Connecting The Sawdust Extraction Device - Parkside PTSS 1200 B1 Manual De Instrucciones

Original accessories/auxiliary
equipment
■ Use only the additional equipment and acces-
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury.
■ Only the original guide rails may be used.
■ All blades used should conform to EN 847-1.

Operation

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
1. Activate the safety lock-out
motor unit forwards.
2. Open the clamping lever
lock-out . The motor unit clicks into place. The
movement of the motor unit is blocked upward
and downward.
3. The clamping screw/washer
tion .
14 b
4. Press the spindle lock button
Hex key to open the clamping screw/
washer .
14a
5. Remove saw blade
NOTE
► Ensure that the factory-fitted flange X stays in
place during installation and removal (see fig. A).
Fig. A
PTSS 1200 B1
and push the
. Release the safety
is now in posi-
14a
and use the
.
X
6. Fitting a saw blade
reverse order.
WARNING!
►
The direction of rotation of the saw blade
and the machine must match.
Connecting the sawdust extraction
device
♦ If required, attach the adapter for dust extrac-
tion to the chip ejector
♦ Connect an approved dust and chip extraction
device.
Check that the blade guard is
functioning
NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
♦ Activate the safety lock-out
circular saw.
♦ Check whether the saw blade
the blade guard and whether it moves back to
its starting position automatically.
Operation
Switching on and off
Switching on:
♦ Push the safety lock-out
in position.
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off:
♦ Release the ON/OFF switch

Setting the cutting depth (dive depth)

♦ Undo the screw for the cutting depth adjust-
ment and push the stop to the desired
cutting depth on the cutting depth scale
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth adjust-
ment .
is carried out in the
.
and lower the
rubs against
upwards and hold it
. Once the saw is
.
:
GB │ IE │
19
.
■