Tabla de contenido
Produktgruppe 512
47 von 48
If dispensing pump capacity is known, this value can be entered directly in the operator level (e.g., dispensing pump 1).
Operator level Main menu Settings Dispensing pump capacity Dispensing pump 1: No .....ml/min OK Back
(until diskette symbol appears) Diskette symbol to save the capacity.
If dispensing pump capacity is not known, the dispensing pump should be calibrated in the operator level (e.g., dispensing pump 1).
Operator level Main menu Settings Dispensing calibration Dispensing pump 1.
Place the dispensing pump's suction hose in a container with a fill line.
Fill the container to the fill line.
Press the 0/1 button (dispensing pump will run for 60 seconds).
Use a beaker or measuring cup to refill the container to the fill line.
Determine the dispensed amount in the beaker/cup and enter it in the display (V:.....ml).
Press the diskette symbol to save the dispensed amount.
Register the refill message (e.g., dispensing pump 1).
Operator level Main menu Settings Dispenser refill message Dispensing pump 1: No
one level) Diskette symbol to save the refill message.
Check dispensing in all programs and adjust as necessary.
Carry out a functional check.
Back up all data via service mode.
ServiceMain menu Backup Backup data for EW Overwrite existing data? Diskette symbol to overwrite EW data.
To quit service mode, switch off the machine.
Finish up:
Check water connections for leaks.
Re-install the liquid dispensing cover on the rear panel.
Re-install the machine lid.
Carry out a safety check.
Reconnect the machine to the electrical and gas supplies and switch it on.
am
24.01.2012
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 09081900
Yes OK Back (to go back
Tabla de contenido
