Diffuser Probe; Static Pressure Probe - TSI VELOMETER 6000 Serie Manual De Uso

A Velocity
Sensing
Port
B Snap Off
Fins
C Probe Collar
D Connecting
Leg
A Rubber Cap
B Probe Collar
C Connecting
Leg

Diffuser Probe

The Diffuser Probe is designed to measure the velocity at diffusers,
registers and grilles. The volume of air being supplied or exhausted can
be determined by multiplying the measured velocity times an air flow
factor.* Refer to page 11 for proper diffuser, register and grille measuring
procedures.
The velocity sensing port (A) senses the velocity at the diffuser, register,
or grille.
The snap-off fins (B) allow you to accurately position the probe vertically,
horizontally or radially.
The probe collar (C) acts as a stop when connecting the probe to the
Range Selector, and the O-ring acts as a seal.
The connecting leg (D) is inserted into the Range Selector.
*Air flow factors, sometimes known as "K" factors, are generally available from the
manufacturer of the grille or diffuser.

Static Pressure Probe

The Static Pressure Probe is designed for measuring duct static
pressure.
The rubber cap (A) provides a seal around the ¼" hole (in the duct)
where measurements are to be taken.
The probe collar (B) acts as a stop when connecting the probe to the
Range Selector; the O-ring acts as a seal.
The connecting leg (C) is inserted into the Range Selector.
Refer to page 8 for the proper static pressure measuring procedure.
5