Setting The "My" Favourite Light Intensity; Deleting The «My» Favourite Light Intensity; Replacing A Lost Or Broken Somfy Io Control Point; 5Hvwrulqj Wkh Ruljlqdo Frq¿Jxudwlrq - SOMFY Variation io Manual Para El Instalador

8.2. Setting the «my» favourite light intensity
1) Press the «my» button to light up the bulb at the pre-set
favourite position.
2) Press and hold the Up or Down button to adjust the light
intensity to suit your needs.
3) When you have reached the desired light intensity, press
the «my» button until the bulb lights up then goes out.
7KH QHZ IDYRXULWH OLJKW LQWHQVLW\ LV VDYHG DQG WKH EXOE
lights up at this intensity.
8.3. Deleting the «my» favourite light intensity
1) Press the «my» button to light up the bulb at the pre-set
favourite position.
2) Press the «my» button until the bulb lights up then goes
out.
7KH IDYRXULWH OLJKW LQWHQVLW\ LV GHOHWHG

8.4. Replacing a lost or broken Somfy io control point

Adding a control point from a programmed control point section 8.1
If there is no longer a control point in the lighting receiver, go to section 8.5
 5HVWRULQJ WKH RULJLQDO FRQ¿JXUDWLRQ
This reset is done with a Somfy io local control point.
This reset deletes all control points.
1
Only perform the double cutout on the Lighting Receiver
On/Off io to be reset.
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 5 to 15 seconds.
3) Cut the power supply for 2 seconds.
 6ZLWFK WKH SRZHU VXSSO\ EDFN RQ WKH OLJKW ÀDVKHV VORZO\
5) Hold down the PROG button: the light comes on then
goes off, and a few moments later the light comes on again.
7KH /LJKWLQJ 5HFHLYHU LR LV QRZ LQ IDFWRU\ FRQ¿JXUDWLRQ
- Repeat the procedures in the "Set-up" section.
© 2015 Somfy SAS. All rights reserved. 01/2015
1
2
3
1
2
1 2
OFF
2 seconds.
3 4
OFF
2 seconds.
5
5 seconds.
ON
15 seconds.
ON
9