Installation guide
4. io Lighting Receiver wiring
The io Lighting Receiver must be installed in a location sheltered from inclement weather and
rain, and out of the reach of children.
-
Cut off the mains power supply.
-
Connect the io Lighting Receiver to the mains as per the
wiring diagram:
-
Supply 230 V = Power supply side (A)
-
Light = Light side (B)
1 Blue
Neutral
2 Brown
Live
A
Green/
Earth
yellow
5. Commissioning
The guide only describes commissioning using a Situo io type Somfy io local control point. For
commissioning using any other io control point, refer to the corresponding guide.
5.1. Identifying setting steps already completed
Only one receiver must be powered at a time.
Switch on the power and follow procedure "a" or "b", according to the light's reaction:
The light comes on then goes out.
a
No Somfy io control point has been programmed.
Go to the section "Programming the first Somfy io local
control point".
or
The light does not come on
b
Press the Up or Down button and follow procedure "c"
or "d", according to the light's reaction:
The light still does not come on
c
No Somfy io control point has been programmed.
Go to the section "Programming the first Somfy io
local control point".
or
d
The light comes on or goes out
The Somfy io control point has been programmed.
Go to the section "Operation".
5.2. Programming the first Somfy io local control point
1)
Press the Up / Down buttons simultaneously on the Somfy
io local control point: the light will come on and then go
out.
2)
Briefly press the PROG button on the Somfy io local
control point: the light will come on and then go out again
to indicate that the Somfy io local control point has been
programmed into the io Lighting Receiver.
Copyright © 2009 Somfy SAS. All rights reserved.
1 Blue
Neutral
2 Brown
Live
B
Green/
Earth
yellow
Lighting receiver io
OFF
A
A
1
2
Programming the
1st Somfy io local
control point.
Programming the
1st Somfy io local
control point.
1
2
PROG. H
B
B
1
2
or
c
d
Operation.
27