Skil 3601 Instrucciones De Funcionamiento Y Seguridad página 20

SM 2610029990 06-13_3601 6/21/13 12:16 PM Page 20
preparing Saw for Rip cutting
See figure 19.
1. Position the Saw Assembly on middle of rail.
2. Insert Saw Assembly locking knob into hole on rail and
ensure saw assembly is locked into place, see figure 11.
3. Remove fence locking knob and remove fence from
miter position.
4. Position threaded piece to right side of table.
5. Position fence on table for ripping.
6. Replace fence locking knob in threaded piece.
7. Adjust front hold down bracket to approximately 1/16"
above workpiece.
8. Lower anti-kickback pawls to its lowest position.
making a Rip cut
See figure 20.
1. Ensure switch is at the "off" position and saw assembly
is in the locked position.
2. Position the fence to the desired width of rip and lock in
place. Before starting to rip, be sure:
a. Rip Fence is parallel to saw blade.
b. Riving Knife is properly aligned with saw blade.
c. Anti-kickback pawls are functioning properly.
3. Turn on the saw and begin to feed the wood onto the
blade, making sure that the edge of the wood is against
the rip fence.
Stay to the side of the workpiece as you feed it onto the
saw to avoid kickback.
Use the push stick to complete the cut past the saw
blade. The use of a pushstick is essential in helping to
ensure safety while using your saw.
Feed the wood into the blade at a smooth and consistent
speed. Keep the wood moving, never stopping as you
make the cut, since this could result in an uneven and
choppy cut.
4. Turn off the saw after the piece of wood has been cut
through. Allow the saw blade to stop completely before
removing the pieces of wood.
operation
FIG. 19
FIG. 20
push Stick
20.