Help - Daewoo DTD-5000 Manual De Instrucciones

USER MANUAL

HELP

Phone does not work
• Have you installed the batteries correctly? See page 31.
• Check that the mains power is correctly connected.
No dial tone
• Is the telephone cord of the base plugged into the phone socket?
• Check that the mains power is correctly connected.
• Only use the telephone cord supplied with the phone.
Cannot dial out or receive calls
• Check that the mains power is correctly connected.
• The batteries may need recharging.
• Has there been a power cut? If so, place the handset back on the base for 10 seconds and try
again. If it still does not work disconnect the batteries and mains power for 10 minutes, then
reconnect and try again.
You have a dial tone, but the phone will not dial out
• You may need to change the dial mode from tone to pulse, see page 44.
• If you are connected to a switchboard, check whether you need to dial an access code.
Handset does not ring
• The ringer volume may be switched off , see page 40.
• Check that the mains power is correctly connected.
• Make sure the handset is registered to the base, see page 48.
No display
• The batteries may be fl at, dead or incorrectly inserted.
• Recharge or replace the batteries.
icon fl ashes
• Is the handset registered correctly to the base, see page 48.
• Check that the mains power is correctly connected.
• Check that the handset is within range of the base.
icon fl ashes
• The batteries are low, place the handset on the base/charger to recharge.
EN
51
DTD 5000