Restore Default Settings; Set The Date/Time - Daewoo DTD-5000 Manual De Instrucciones

USER MANUAL
There are 2 recall mode settings:
Recall – for time break recall. This is the default setting.
Earth – for earth loop recall.
1. Press to open the main menu.
/
2. Press or until Setup is displayed, then press
3. Press or to select Recall Mode and press
4. Use or to highlight the recall setting you want and press
5. Press repeatedly to exit and return to standby.
/

Restore default settings

You can restore your phone to its default (original) settings.
1. Press / to open the main menu.
2. Press or until Setup is displayed, then press
3. Press or to select Default and press
4. Enter the 4 digit PIN code and press
5. Confi rm? is displayed, press
on again with the default settings restored.
Please note, restoring the default settings will delete your phonebook, redial and calls list.
Restore default settings without a PIN
If you have forgotten your PIN code, you can restore your phone to the default settings following the
procedure shown below.
1. Unscrew and remove the belt clip and battery compartment cover.
2. Remove the batteries for a few minutes. Press and hold
insert the batteries again observing the polarity markings (+ and -).
3. Default is displayed, press
When the phone powers up, the default settings will be restored.
Set the date and time
1. Press to open the main menu.
/
2. Press or until Date & Time is displayed, then press
EN
/
.
/
/
.
/
.
/
to confi rm the reset. The handset will switch off , then switch back
/
.
/
45
.
to confi rm your selection.
/
.
, while still pressing the
.
/
DTD 5000
button,