Residual Risk Factors - HOLZMANN MASCHINEN ABS 3000 Manual De Instrucciones

The electric connection of the machine to the power supply must be carried out
by a trained electrician.
The power supply must be grounded and has to have a short-circuit protection.
The power socket must be grounded and suitable for 16A.
For further details consult section 4.2 of this manual.
Disconnect the machine from the power supply prior to performing maintenance
or other activities.
Never use the power cord to transport the machine or pull it around.
If an extension cord is required, it has to have a sufficient cross-section, but at
least 1,5mm².
Control periodically the condition of power plug, power socket power cords. Re-
place immediately if damaged.
Do not insert any objections into the dust collector hood and keep hand away
from the dust collector hood when machine is connected to power supply.
Regularly check the dust collector hood for debris and clean it if necessary.
Do not dismount the protective fence in the dust collector hood. It is a security
component and must be left in place.
3.1

RESIDUAL RISK FACTORS

Despite of correct and proper use and maintenance there remain some residual risk factors:
Hazard of injury or machine damage due to undetected machine defect
To minimize this risk, check the machine prior to every operation for loose screws and
connections. Check the motor noise, the collector tubes, filter bag, dust collector bag and
impeller for eventual damage. Damaged parts have to be replaced immediately, no opera-
tion of the machine in the meantime!
Hazard of electric shock
Undetected malfunctions in the power supply and/or the connected wood working machine
might result in electric shock when touching the machine. Ensure proper electric installa-
tion, and let it check periodically by a trained electrician.
Danger due to unintended machine start-up
Eliminate this risk by disconnecting the machine before you perform any checks or activi-
ties on the machine.
Hazard of inhaling toxic wood dust
Especially wood dust arising from chemically treated wood and/or lacquer/paint are harm-
ful when inhaled. Therefore let the dust settle for 10 Minutes before you change the dust
collector bag and wear a suitable breathing mask if required.
HOLZMANN Maschinen Austria
Operation Manual ABS 3000/5000
www.holzmann-maschinen.at Seite 15