Wolf Garten Ambition Robo Scooter 300 Instrucciones De Servicio página 81

0030
Start Inside
0031
Stuck in place
0060
Check Intensity
0061
Decrease
Inactive Time
9.3 User Messages
The next table gives information about User Messages that can be displayed on the mower:
Display
BATT
Recharge Battery. Low battery voltage.
Test Base Station position.
U001
Displayed during the One-Time Setup.
Peg Base Station.
U002
Displayed during the One-Time Setup.
Test wire position.
U003
Displayed during the One-Time Setup.
Test wire ended (during the One-Time Setup)
U004
Displayed only when using the Unit App.
U018
Operation time is shorter than expected
Keep charging if not used.
U024
Displayed only if the mower is disconnected from a
Charging Adaptor.
U025
Switch Off before lifting
Change the wires in plot connector
U029
Displayed during the One-Time Setup.
Switch on the System Switch.
U032
Displayed if the mower is connected to charging, but the
System Switch is 'Off'.
U041
N/A
U042
N/A
U043
N/A
U044
N/A
Reposition the Base Station position.
U051
Displayed during the One-Time Setup.
U052
Adjust Wire
U062
An alarm will soon be activated.
The Searching Base Station operation cannot be
U064
performed
Waiting for the signal...
U086
The unit has stopped the operation. It does not detect a
signal.
Mow motor overheat, Cooling...
U087
The mowing motor has been working under a severe load
for too long.
Drive motor overheat, Cooling...
U088
The drive motors have been working under a severe load
for too long.
Capitolo 3 - Messaggi testuali e riparazione dei guasti
en
Automatic operation is initiated while the robot
is placed out of the Perimeter Wire loop.
See E1 in the above table
The Intensity you have set is too high for your
lawn area.
See E8 in the above table
Message / Description
Place the mower inside the lawn and renew the
operation.
Decrease the Intensity you have set for the zone(s) in
your lawn
Action Required
Recharge the Battery.
Refer to section 5.2.4 in the User Manual.
Refer to section 5.2.4 in the User Manual.
Refer to section 5.2.5 in the User Manual
No action is required.
Battery run time is too short. Replace Battery.
It is recommended to keep the mower connected to the Power
Supply when not in use.
It is required to switch Off the System Switch before lifting
and carrying the mower.
Swap the wires at the plot connector.
Refer to section 5.2.4 in the User Manual.
Switch the System Switch to 'On'.
N/A
N/A
N/A
N/A
Refer to section 5.2.4 in the User Manual.
Refer to section 5.2.5 in the User Manual.
This message warns you to enter the PIN code before the
Anti-Theft alarm will sound.
When choosing the 'Home' button in a zone without a Base
Station.
Check the power to the Power Box.
There may be an electrical power interruption. There is no
need to do anything. The unit will renew operation as soon as
the power is back on.
No need for action – the unit will renew automatically the
operation, as the mowing motor will cool down.
No need to do anything.
The unit will renew the operation automatically as soon as
the drive motor will cool down.
81