Wolf Garten Ambition Robo Scooter 300 Instrucciones De Servicio página 70

5.3.5 Test Wire Position
•
U003
is displayed
•
The unit will follow the wire along the edge to test the wire
position.
Walk alongside the unit while it is following the edge.
Having completed the process, the unit will enter the Base
Station and the setup process is completed.
If the mower collides with obstacles along the edge,
the mower will stop and drive backwards with
U052
• Move the wire slightly inward.
• Press OK to continue the Wire Test.
•
If, at any point, you wish the mower to drive closer to the
edge to enlarge the covered area, press Stop
displayed -
Move the wire slightly outward.
Place the mower in front of the changed section of wire.
Press OK to continue the 'Test Wire Position' process.
• If you want to quite the setup process, press the
continuously for 3 seconds. The screen will change to the
Main Display (current time).
• After completing the Test Wire Position, test the mower in
Near Wire Follow mode to confirm it completes the drive
near the wire smoothly, without acquiring any adjacent wire
or hitting any obstacle on its way to the Base Station.
• If the mower fails to complete the Near Wire Follow
smoothly to the Base Station, then reduce the Near Wire
Follow Distance (Menu P004) and repeat the test until it will
complete the drive smoothly.
5.3.6 After Setup is Completed
Once the wire setup is complete, drive additional pegs at a distance
of approximately 0.75 m (2.5 ft.) apart.
• Use additional pegs in areas where there are bumps or dips in the
lawn.
If needed, purchase extra pegs.
• Inspect the wire installation for tripping hazards.
70
press OK
displayed:
U003
STOP
button
is
en