Initial Setup; Getting Ready - Wolf Garten Ambition Robo Scooter 300 Instrucciones De Servicio

4. Initial Setup

4.1 Preparations
Recommendation before you start:
During setup, you will insert pegs into the ground. To complete
this task smoothly, we recommend not to do it while the grass is
high and to water it before starting.

4.1.1 Getting Ready

Make sure all parts needed for setup are within reach. Have the
unit box nearby, so all items are available.
In addition, you will need the following tools: A hammer, small
flat screwdriver, Phillips screwdriver, Combination Pliers.
4.1.2 Installing the Power Box
Mount the metal bracket onto a vertical surface with the provided
screws. Make sure the narrow part with the holes facing up as
shown in the figure to the right.
• Place the Power Box above the metal bracket and slide it into
place along the vertical surface.
• Connect the Power Box to a regular power outlet (230V /
120V).
4.1.3 Charging the battery before the first operation
You can charge the unit battery while running the setup of the
Perimeter Wire. This will ensure that the unit will be ready for
operation when the setup is completed.
• The power of the mower is switched off when shipped from
the factory. Press the 'Settings' button on the Operating Panel
for 3 seconds to awake the mower.
• Connect the DC Cable coming from the Power Box to the
Charging Socket at the rear side of the unit.
• Confirm the Battery LED on the unit is blinking, which is an
indication of charging.
• Leave the unit connected to the Power Box while completing
the setup of the Perimeter Wire.
4.2 Perimeter Wire Setup
Before you start the setup, you should have a plan for the Perimeter Wire layout and for the location of the Base Station.
Your plan should consider the following:
o
What type of lawn areas does your lawn have?
(Main Zone / Separated Zones / combination of types).
o
Are there protected or excluded areas on the lawn? (Perimeter Islands).
o Are there any slopes that the unit should avoid?
o
Are there edges of pools, ponds, cliffs etc., that need an extra distance from the Perimeter Wire?
58
en