Battery Change - TFA Dostmann 35.1023 Manual De Uso

Change of Base Address for Sensors with fixed Assignment
Setting of addresses for the Remote Indoor Sensor, Remote Rain Volume Sensor
and Remote Wind Sensor is not required under normal operating conditions.
Multi functional operation is a special feature, allowing to generally operate an
arbitrary number of Base Units within the transmission range of the Remote Sensors.
One Base Station can be placed in the living room, one in the office, etc., all displaying
the same data.
If in every room, in which a Base Station (Display Unit) has been placed, the indoor
temperature of this particular room needs to be displayed on the upper left section
of the LCD, then the indoor sensors for temperature/humidity and air pressure need
to be assigned different base address according to the illustration opposite.
In order for the Base Station to exclusively receive its assigned sensor here also a
respective address has to be set. To
change the base address in Calibration
Mode the (←) key must be pressed three
times and the desired base address
selected by use of the „Indoor" key.
The base addresses of the Wind Sensor
and the Rain Volume Sensor can also be
changed in this operating mode which
however is only necessary in very rare
cases. A change of address is only
required if two neighbouring Wind Sensors
or Rain Volume Sensors are placed within
the reception range of the Base Station.
The base address of the Wind Sensor and the Rain Volume Sensor can only
exclusively be changed by the manufacturer, thus requiring the units to be shipped
back to the manufacturer, if necessary.
Note on Storage of Solar Powered Outdoor Sensors
These sensors receive their operating power from a solar cell which also powers an
internal battery to be used during periods of darkness and bad weather.
If any such sensor is taken out of operation for a longer time period without any
light there still is no danger for the internal battery as long as the small magnet
required for activation of operating power has been removed.
This way a sensor in its packaging can be stored for several years.

13. Battery Change

Remote Indoor Sensor, Remote Sensors WS 2200-22 and WS 2200-27
The batteries in these sensors have a life expectancy of up to 3 years (Alkaline
Batteries). They have to be changed, if the display of the respective sensor in the
base station fails to appear for a time period exceeding 24 hours and any general
52
Adresse
Jumper
1 0
7 A0
JP1
JP2 A1
JP3
A2
A0
JP1
6
A1
JP2
A2
JP3
A0
5 JP1
A1
JP2
JP3 A2
4
JP1
A0
JP2
A1
JP3
A2
Jumper
Adresse
1 0
JP1 A0 3
JP2
A1
JP3
A2
JP1 A0
2
JP2
A1
JP3
A2
JP1 A0
1
JP2
A1
JP3
A2
JP1 A0
0
JP2
A1
JP3
A2