Programming Mode - TFA Dostmann 35.1023 Manual De Uso

Sensor Selection
The „Sensor" key allows in all operating modes of the Weather Station the selection
of the Outdoor Temperature/Humidity Sensors. The selected sensor will in the „Sen-
sor" display section be displayed with its assigned identification number.
Outdoor
In normal operating mode the outdoor display in the upper right of the LCD displays
the temperature and humidity at the location of the Outdoor Sensor selected by
use of the „Sensor" key.
By once pressing the „Outdoor" key the Dew Point will be displayed. By twice
pressing the „Outdoor" key the temperature display in this section will change to
the display of the Windchill Equivalent Temperature (Perceived Temperature).
Windchill display will of course only be possible if a Remote Wind Sensor is part of
the Weather Station System.
One more pressing of the „Outdoor" key will lead back to the normal temperature
display.

11. Programming Mode

In programming mode all the minimum and maximum value settings for the alarm
functions can be performed.
Please observe that for this mode only the imprints below the functions keys will
apply. If the „Store" key is pressed or no key is pressed for about 60 seconds the
device will automatically switch back to its normal operating mode.
In order to enter the Programming Mode both Arrow keys (←) and (→) must be
pressed simultaneously. The display will now show the symbol „Pr" instead of the
time as well as the set minimum alarm value. Weather icons, air pressure tendency
display, air pressure history and compass will be switched off.
By once pressing the „Min/Max" key, the maximum alarm value will be displayed.
By again pressing the „Min/Max" key, the system will return to the display of the
minimum alarm value. The alarm values, such as for exceeding or falling below a
certain ground temperature, for a certain wind strength, etc., can now be set in
Programming Mode. By pressing the „Store" key the Programming Mode can be
left.
Setting of the Minimum/Maximum Alarm Values
By use of the Arrow keys (←) and (→) and possibly the „Sensor" key select the
desired measuring point or measuring value respectively. All other displays will
stay switched off.
48