Easy Connections - Pioneer DV-656A Manual De Instrucciones

Connecting Up

Easy connections

TV
OPTICAL COAXIAL
L
IN OUT
R
DIGITAL AUDIO AUDIO
CONTROL
OUT OUT
(2ch)
The setup described here is a basic setup
that allows you to play discs using just the
cables supplied with the player. In this setup,
stereo audio is played through your TV.
• This player is equipped with copy
protection technology. Do not connect
this player to your TV via a VCR using AV
cables, as the picture from this player
will not appear properly on your TV. (This
player may also not be compatible with
some combination TV/VCRs for the
same reason; refer to the manufacturer
for more information.)
1 Connect the VIDEO OUT (1) and
AUDIO OUT (2ch) jacks to a set of A/V
inputs on your TV.
Use the supplied red/white stereo audio and
yellow video cable. Make sure you match up
the left and right audio outputs with their
corresponding inputs for correct stereo
sound.
A/V IN
AV CONNECTOR 1 (RGB)-TV
L CENTER
1 2
AUDIO OUT
(5.1ch)
SUB
R
WOOFER
FRONT SURROUND
S-VIDEO
OUT
AV CONNECTOR 2
1 2 Y
P P
B R
VIDEO COMPONENT VIDEO OUT
OUT
To power outlet
See the next page if you want to use an
S-video, component or a D video connection.
• If you need another pair of stereo
outputs (and don't need to use the
multichannel analog outputs), you can
use the AUDIO OUT (5.1ch) FRONT
L / R jacks (page 13).
2 Connect the supplied AC power cord
to the AC IN inlet, then plug into a power
outlet.
• Before unplugging the player from the
power outlet, make sure you first switch
it into standby using either the front
STANDBY/ON button, or the
panel
remote control, and wait of the -OFF-
message to disappear from the player's
display.
• For the above reasons, do not plug this
player into a switched power supply
found on some amplifiers and AV
receivers.
02
11
En