AD Instruments AD1062P Manual De Usuario página 215

PasslFail
The Pass/Fail function monitors changes of signals and output pass or fail signals by
comparing the input signal is within the pre-defined mask.
Utility→Pass/Fail
Press to go to the following menu.
The Pass/Fail menu (Page 1/2)
The Pass/Fail menu (Page 2/2)
The Pass/Fail menu table (Page 1/2)
Menu Setting
Enable ON
OFF
Source CH1
CH2
Output Fail Pass
Fail+Beep
Pass +Beep
Operate Stop
Start
1/2
The Pass/Fail menu table (Page 2/2)
Menu Setting
2/2
Figure 2-45 The Pass/Fail menu
Figure 2-46 The Pass/Fail menu
Description
Turn on Pass/Fail test
Turn off Pass/Fail test
Select Pass/Fail test on CH1
Select Pass/Fail test on CH2
Output when Fail condition detected
Output when Pass condition detected
Output and Beep when Fail condition detected
Output and Beep when Pass condition detected
Pass/Fail test stopped, press to run
Pass/Fail test running, press to stop
Go to the next menu page
Description
Back to the previous menu page
49