AD Instruments AD1062P Manual De Usuario página 203

Auto
Sweep Normal
Single
HF ON
Reject OFF
Pulse Trigger Setting
Pulse trigger occurs according to the width of pulse. The abnormal signals can be
detected through setting up the pulse width condition.
Press TRIG → Fl → Pulse button to show the pulse trigger menu as the following table.
The Pulse Trigger Menu (Page 1/2)
The Pulse Trigger Menu (Page 2/2)
Menu Setting
CH1
Source
CH2
+more
+Less
+Equal
When
-more
-Less
-Equal
Setting Value
1/2
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then stop
Reject high frequency signals
Figure 2-27 The Pulse Trigger Menu
Figure 2-28 The Pulse Menu
The Pulse Trigger Table (Page 1/2)
Define CHl or CH2 as trigger signal
+Pulse width more than
+Pulse width less than
+Pulse width equal to
-Pulse width more than
-Pulse width less than
-Pulse width equal toTo select pulse condition.
Set required pulse width.
Go to the next menu page
37
Description