Tabla de contenido
Idiomas disponibles
Idiomas disponibles
AD2817C Operation Manual
2.6 Function
2.3.1 Correction
Open correction:
to eliminate measurement errors due to parasitic stray admittance (C,
G) of the test fixture.
Short correction:
to eliminate measurement errors due to parasitic residual impedances
(L, R) of the test fixture.
Cable length calibration:
0m: to measure with terminal fixture;
1m: to measure with 1m cable of TH26009, TH26011
CUST: to calibrate with cable of required length. And the shipped instrument hasn't been
performed calibration.
Correction function can be turned off.
2.3.2 Comparator
The instrument can perform multi-bin sorting and support signal output of HANDLER
interface.
BIN1 to BIN3:
Both primary and secondary measurement parameters are within limits.
OUT BIN:
Primary parameter is not within limits. Or primary parameter is within limits,
secondary parameter is not within limits, and AUX bin is off.
AUX BIN:
Primary parameter is within limits, but whose secondary parameter
measurement result is not within limits.
Sorting mode:
ABS (absolute deviation):
value is compared with bin limit.
PER (percentage deviation):
nominal value is compared with bin limit.
2.3.3 Parameter display
Direct:
The actual measured values will be displayed.
:
Absolute devation between measured result and nominal value is displayed.
%:
Percentage deviation between measured result and nominal value is displayed.
2.3.4 Transformer parameter measurement
AD2817C has the function of measuring basic parameters of single transformer through
2-wire mode. And special test fixture should be used at the time of transformer
measurement.
absolute deviation between measured result and nominal
percentage deviation between measured result and
11
Capítulos
Tabla de contenido
