AD2817C Operation Manual
3)
ERASE
Perform the following steps to erase file:
a)
Select "ERASE" at file operation page through
Figure4-29.
b) Press ▲ or ▼ key to select erasing file No. Displayed "Y" means the file has existed,
and "N" means the file doesn't exist.
c)
Press ENTER key to perform the erasing operation, and hint "SURE" to ensure the
operation, press ENTER key to erase the file, otherwise, press ERC key to give up the
operation.
d) Press ESC to exit.
4.2.16 System function setup
System setup includes the following items:
BUS:
ADDR:
BAUD:
DELIM:
FETCH:
TRGEG:
HD:
ALARM:
SOUND:
KBEEP:
KLOCK:
SAVE:
Perform the following steps to enter system setup page:
3.
At test status, press SHIFT key, and "SHIFT" at left corner is on.
4.
Press SYSTEM key to enter system setup page, as shown in 4-30.
Figure 4-28 Loading file
Figure 4-29 Erasing file
BUS mode
GPIB address;
RS232C communication baud rate;
ending symbol;
fetch mode;
HANDLER interface's trigger edge;
HANLDER interface's signal hold;
comparator alarm;
alarm sound;
key beep on/off;
key lock on/off;
saving system setups
or
35
key, as shown in