Machine Set Up; To Install Drum; To Install Guard; Machine Transport - RIDGID Kollmann K-375 Manual Del Operador

Kollmann

Machine Set Up

NOTE! FOR/OFF/REV switch should be OFF and machine
unplugged before installing or removing drum.
WARNING
Guard must be installed before operating machine.
Injury to fingers, hands, arms or other body parts
could occur if caught in pulley and belt.

To Install Drum

1. Align bearing bore in back of drum with shaft.
2. Let drum slide down shaft so that the locking mech-
anism catches. In locked position, drum will rotate
freely but should not slide forward without pulling the
release pin.
3. Engage V-belt drive with drum. Push down on top of
motor so that you depress the two large springs un-
derneath the motor table and slip belt over drum.
NOTE! Make sure belt properly contacts drive pulley be-
fore slipping over drum.

To Install Guard

1. Fasten guard to motor using the two (2) wing nuts.
2. Adjust guard so that it is approximately
drum.
WARNING
Gap between bottom of guard and drum should
not exceed 1 / inch. Larger gap could result in fin-
2
gers being caught.

Machine Transport

It is easier to transport machine with the drum removed.
Separating drum from machine frame creates a bal-
anced, two-handed load.
6
K-375 Drain Cleaning Machine
1 / inch from
4
Ridge Tool Company • Elyria, Ohio • U.S.A.

To Remove Drum

NOTE! FOR/OFF/REV switch should be OFF and machine
unplugged before removing or installing drum.
1. Disengage the V-belt drive from the drum. (Figures 1
and 2)
Figure 1 – Push down on
motor to release spring
tension on belt
2. Rotate the drum so that the release pin is in the 12
o'clock position and is easily accessible. (Figure 3)
Figure 3 – Rotate drum so release pin is easily accessible
Figure 4 – Lift release pin UPWARD to release drum lock
mechanism
Figure 2 – With belt tension
released, slip belt off drum