Operating States/Error Signals; Error Messages While Establishing A Connection - Ottobock 4X350 Instrucciones De Uso

the instructions of your national authority pertaining to return and
collection.
Declaration of conformity according to the applicable European
directives and the number of the notified body (0681)
Non-ionising radiation
Compliance with the requirements according to "FCC Part 15"
(USA)
Compliance with the requirements according to the "Radiocom­
munications Act" (AUS)

11.2 Operating states/error signals

11.2.1 Error messages while establishing a connection

Error message
Device not found
42 | Ottobock
Cause
A previously saved
connection to the
prosthesis could
not be established.
Correction
Check the following points:
• Distance from the prosthesis
to the remote control
• Battery charge level of the
prosthesis
• If multiple prostheses were
stored in the remote control,
was the correct prosthesis
selected?
1) Connect the battery charger
to the prosthesis, then charge
the battery for at least 3
hours. You can try to estab­
lish connection again while
the battery is charging.
2) Use the key to confirm the
error message and try to
establish
again.
the connection