Ottobock 4X350 Instrucciones De Uso página 30

→ If names of prostheses appear in the display, prostheses are
already saved in the remote control. Continue with the steps listed
in section "Managing prostheses (see Page 35), part 'Adding new
(prosthesis) connection' (menu item 'Pairing')".
3) Compare the serial number that is displayed to the serial number of the
prosthesis you want to connect to.
If the serial number 000000000 is displayed (multiple prostheses in
range), use the , ,
thesis you want to connect to.
4) Confirm with the key.
→ Once the connection has been established successfully, the data
are read from the prosthesis (see fig. 8). This process may take a
few minutes.
→ The main menu is then displayed on the remote control and
includes the name of the connected prosthesis, the battery charge
level of the remote control, the charge level of the prosthesis and
the mode that is currently set (1 = basic mode).
INFORMATION: The name of the prosthesis can only be
entered or changed using the adjustment software.
INFORMATION
After the initial connection to the prosthesis has been established success­
fully, the remote control will connect automatically each time it is turned on
( key followed by
8 Use
8.1 MyModes
With the help of adjustment software, the prosthetist can activate and config­
ure MyModes in addition to the basic mode. These modes are intended for
specific motion patterns or postures (e.g. inline skating, ...) and can be
accessed using the remote control.
Changes to the prosthesis settings can be made as well.
The number of MyModes that can be used depends on the configuration
using the adjustment software and on the respective prosthesis.
30 | Ottobock
, keys to enter the serial number of the pros­
key). No further steps are required.