The Scope And Suggestions For Uses; How To Select Tightening Torque - Hitachi DS 9DVF Manual De Instrucciones

English

THE SCOPE AND SUGGESTIONS FOR USES

Work
Wood
Drilling Steel
Aluminum
Machine
screw
Screw
Wood
tightening
screw

HOW TO SELECT TIGHTENING TORQUE

Cap
position
1 Approximately 9 in-lbs. (10 kg-cm)
3 Approximately 15 in-lbs. (17 kg-cm)
7 Approximately 23 in-lbs. (26 kg-cm)
13 Approximately 35 in-lbs. (40 kg-cm)
17 Approximately 43 in-lbs. (49 kg-cm)
22 Approximately 52 in-lbs. (60kg-cm)
High speed: approximately 5 in-lbs.
Low speed: approximately 156 in-lbs.
NOTE:
The selected content shown in Table 4 indicates the differences according to screw type,
screw size and material used.
CAUTION:
While operating the Cordless driver drill, take care not to lock the motor.
If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery will be burnt.
Do not tighten too strongly as the screw heads will be damaged.
20
Table 3
Cap position
1 – 22
1 –
Table 4
Tightening torque
(60 kg-cm)(DS9DVF)
approximately 61 in-lbs.
(70 kg-cm)(DS12DVF)
approximately 70 in-lbs.
(80 kg-cm)(DS14DVF)
(180 kg-cm)(DS9DVF)
approximately 191 in-lbs.
(220 kg-cm)(DS12DVF)
approximately 213 in-lbs.
(245 kg-cm)(DS14DVF)
Suggestions
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
Machine screw tightening
Screw tightening for soft
wood material
Screw tightening for hard
wood material
Thick screw tightening
When used as a drill.
Operation example