Mounting The Handle - Makita EM2600U Instrucciones De Manejo

Mounting the handle

CAUTION: Before doing any work on the brush cutter, always stop the engine
and disconnect the spark plug connector from the spark plug.
Always wear protective gloves!
CAUTION: Ensure you have reassembled the brush cutter completely before
starting it.
For U handle models
– Place the two handles onto the handle holder. The control lever must come
right side when you look towards the cutting tool.
– Fit the handle ends to the groove on the handle holder and fit the clamp on
them. Loosely tighten them with four bolts for adjustment.
– Adjust handles' angle, and then tighten all bolts evenly by a hex wrench.
– Place the throttle cable (1) to the control lever side of the shaft. And then wrap
them with the waist pad (2).
– Insert the throttle cable (1) into the clamping slot (3) of the handle holder.
– Make sure the throttle cable is positioned as shown.
– Operate the control lever and make sure it moves smoothly.
CAUTION: Do not position the throttle cable as shown. Otherwise curved cable
may cause high idle speed, and uncontrollable blade may cause
personal injury.
L
9
R
EM2600U
(2)
(1)
EM2600U
(3)
(1)
EM2600U
EM2600U