Product Dimensions; Gas Supply Requirements - KitchenAid 720-0787D Manual De Uso

Product Dimension
12. 6"
( 32cm )
The model/serial number rating plate is located on the
inside of the cabinet door. See the following illustration.
A. Model/Serial number plate
6
50. 3"
26. 2"
( 127. 8cm )
( 66. 5cm )
54 3, 36
12. 6"
( 32cm ) ( 32cm )
48. 4"
( 122. 9cm )
584 , 19
23. 6"
( 60cm )
A

Gas Supply Requirements

Observe all governing codes and ordinances.
IMPORTANT: This installation must conform with all local
codes and ordinances. In the absence of local codes,
installation must conform with either the National Fuel Gas
Code, ANSI Z223.1/NFPA54, Natural Gas and Propane
Installation Code, CSA B149.1, Propane Storage And
Handling Code, B149.2, or the Standard for Recreational
Vehicles, ANSI A119.2/NFPA 1192 and CSA Z240 RV Series
Recreational Vehicle Code as applicable.
IMPORTANT: Grill must be connected to a regulated gas
supply. Refer to the model/serial rating plate for information
on the type of gas that can be used. If this information does
not agree with the type of gas available, check with your
local gas supplier. g pp
Gas Conversion:
No attempt shall be made to convert the grill from the gas
specified on the model/serial rating plate for use with a
different gas type without consulting the serving gas
supplier. The conversion kit supplied with grill must be used.
See "Gas Conversions" section for instructions.
Gas Pressure Regulator
The gas pressure regulator supplied with this grill must be
used. d
The inlet (supply) pressure to the regulator should be as
follows for proper operation:
LP Gas:
Operating pressure: 11" (27.9 cm) WCP
Inlet (supply) pressure: 11" to 14" (27.9 cm to 35.5 cm) WCP
Natural Gas:
Operating pressure: 4" (10.2 cm) WCP
Inlet (supply) pressure: 7 to 14 (17.8 cm to 35.5 cm) WCP Inlet (supply) pressure: 7" to 14" (17 8 cm to 35 5 cm) WCP
maximum.
Contact local gas supplier if you are not sure about the inlet
(supply) pressure.