Parking Brake Check; Engine Oil Level Check; Engine Oil Change; Engine Oil Filter Replacement - Nilfisk Advance RS 1300 Instrucciones De Uso

ENGLISH

PARKING BRAKE CHECK

Check
1. Engage the parking brake lever (13, Fig. E) and check for proper operation. Check also that the brake operates in the same
way on both the front wheels.
If necessary, adjust the parking brake according to the instructions in the Service Manual.

ENGINE OIL LEVEL CHECK

1. Engage the parking brake (13, Fig. E).
2. Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
3. Open the left side upper and lower doors (9 and 11, Fig. G) by disengaging the fasteners (10 and 12) with the supplied key.
4. Check the oil level as shown in the Diesel Engine Manual.
5. Close the left side upper and lower doors (11 and 9, Fig. G) by engaging the fasteners (10 and 12) with the supplied key.

ENGINE OIL CHANGE

1. Empty the hopper (6, Fig. G); if it contains a small quantity of waste, it is not necessary to dump it.
2. Drive the machine on a solid and level ground, then engage the parking brake (13, Fig. E).
3. Lift the hopper (6, Fig. G), according to the procedure shown in the relevant paragraph.
4. Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
5. To avoid that the hopper lowers by accident, install the lifted hopper support rods (3, Fig. F), according to the instructions
shown on the relevant paragraph.
6. Close the left and right side upper doors (9 and 28, Fig. G) by engaging the fasteners (10) and (29) with the supplied key.
7. Remove the screws, then remove the engine compartment panel (11, Fig. F).
8. Open the left side lower door (11, Fig. G) by disengaging the fastener (12) with the supplied key.
9. Change the oil as shown in the diesel engine Manual.
10. Perform steps 3 to 8 in the reverse order.

ENGINE OIL FILTER REPLACEMENT

NOTE
This procedure must be performed when the engine oil has been drained.
1. Empty the hopper (6, Fig. G); if it contains a small quantity of waste, it is not necessary to dump it.
2. Drive the machine on a solid and level ground, then engage the parking brake (13, Fig. E).
3. Lift the hopper (6, Fig. G), according to the procedure shown in the relevant paragraph.
4. Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
5. To avoid that the hopper lowers by accident, install the lifted hopper support rods (3, Fig. F), according to the instructions
shown on the relevant paragraph.
6. Close the left and right side upper doors (9 and 28, Fig. G) by engaging the fasteners (10) and (29) with the supplied key.
7. Remove the screws, then remove the engine compartment panel (11, Fig. F).
8. Open the right side door (34, Fig. G) by disengaging the fastener (35) with the supplied key.
9. Replace the oil fi lter as shown in the Diesel Engine Manual.
10. Perform steps 3 to 8 in the reverse order.
CAUTION!
When replacing the engine oil fi lter, it is recommended to change the engine oil as shown in the relevant
paragraph.
46
INSTRUCTIONS FOR USE
33018312(3)2010-01 RS 1300