Nilfisk Advance RS 1300 Instrucciones De Uso página 34

ENGLISH INSTRUCTIONS FOR USE
• Consultation of B_BOX
alarms occurred after the last memory reset are stored.
The alarm is identifi ed by a number code that can be
displayed as shown below: repeatedly press the upper
part of the push-button (15, Fig. D) until "MAIN MENU"
appears. Confi rm by pressing the lower part of the
push-button (15, Fig. D). The arrow cursor (1, Fig. J)
will be placed near the word "STATUS". Press the lower
part of the push-button (15, Fig. D) again to bring the
arrow cursor near the word "MAINTENANCE". Confi rm
by pressing the upper part of the push-button (15, Fig.
D). On the display (17, Fig. D) the page "MAINT.01"
is shown; when pressing the upper part of the push-
button (15) again, the page "MAINT.02" is shown.
When pressing the lower part of the push-button (15,
Fig. D), the cursor aligns with B_BOX, then enter the
B_BOX by pressing the upper part of the push-button
(15). In this page, the fi rst series of numbers (31, Fig.
J) indicates the alarm identifi cation number, while the
second series of numbers (32) indicates the time at
which the alarm occurred. The stored alarms are up
to 16 displayed on four pages, which can be scrolled
by pressing the push-button (15, Fig. D) repeatedly.
The alarms shown are both instrument inner alarms
and AIA control board transmission line inner alarms
indifferently.
CAUTION!
In the B_BOX the alarms are stored one
after the other, so when the alarms are
detected, always check for the time at
which the alarm occurred to have a real
chronology of the alarms.
12 33018312(3)2010-01
(30, Fig. J), where all the Combination switch functions:
– Headlights off, with mark (35b) at the symbol O
– Running lights on, with mark (35b) at the symbol
– Low beam on, with mark (35b) at the symbol
When the combination switch is in this position, the
working light turns on too.
– High beam on, with mark (35b) at the symbol
lowered lever (35a)
– High beam temporary on, lifting the lever (35a)
– Right turn signal on, bringing the lever (35a) forward
– Left turn signal on, bringing the lever (35a) backward
– Horn activation, pushing the lever (35a) in the direction
shown by the arrow (35c)
Description of the control area
(See Fig. E)
1. Machine serial number plate (in some countries, this plate
is replaced by the diesel engine serial number plate)
2. Cab vents
3. Electrical panel (**)
4. Cab air recirculation vents
5. Climate control knob
6. Cab air fl ow control knob
7. Brake fl uid tank
8. Driver's seat safety belt (*)
9. Electrical component protection panel
10. Dust control system nozzle valve:
• Suction hose (from suction inlet to hopper)
• Rear suction pipe (*)
11. Side broom dust control system nozzle valve
12. 3rd broom dust control system nozzle valve
13. Parking brake lever
14. Driver's seat
15. Cab heater control knob
16. Diesel engine throttle lever
17. Driver's seat forward/backward adjustment lever
18. In-line fi lter
19. Accessory distributor pressure inlet
20. Drive system pump pressure inlet
(*) Optional
(**) See the electrical panel functions below.
RS 1300
.
and