Nilfisk Advance RS 1300 Instrucciones De Uso página 49

Ocultar thumbs Ver también para Advance RS 1300:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Stopping the machine in working mode
31.
To stop the machine release the pedal (26, Fig. D).
To stop the machine quickly, press also the brake pedal (31, Fig. D).
32.
Engage the parking brake with the lever (13, Fig. E).
33.
Turn off the dust control system water pump with the switch (27, Fig. D).
34.
If open, close the dust control system valves (10, 11, 12, Fig. E).
35.
Lift the 3rd broom by pushing the joystick (46, Fig. D) rearward.
36.
Lift the suction inlet and side brooms by pressing the push-button (38, Fig. D).
37.
Turn the engine throttle lever (16, Fig. E) to idle, and hold it in this position for a few minutes to let the system stabilize.
38.
Check that the hopper (6, Fig. G) is lowered and that the warning light (3, Fig. D) is off.
39.
If necessary, bring the 3rd broom from opened position to closed position according to the following procedure:
With the spring-return switch (34, Fig. D), check that the 3rd broom arm extension (22, Fig. G) is to the right end of stroke.
Otherwise bring it to the above-mentioned position by pressing and holding the switch (34, Fig. D).
Shift the 3rd broom arm (23, Fig. G) from opened position to closed position by pushing the joystick (46, Fig. D) to the left.
The shifting operation will stop automatically when the end of stroke is reached.
WARNING!
It is possible to shift to the left or to the right the 3rd broom arm (23, Fig. G) safely, only when the arm extension
(22) is to the left or right end of stroke.
In this situation the arm shifting angle is limited by proper safety devices.
In other situations, the shifting angle is limited to avoid damaging the machine or affect its stability.
It is therefore advisable to bring always the 3rd broom arm extension (22, Fig. G) to the left or right end of
stroke.
WARNING!
It is possible to bring the 3rd broom arm (23, Fig. G) to closed position, only when the arm extension (22) is to
the right end of stroke.
40.
Turn off the 3rd broom, the side brooms and the suction fan with the switch (29, Fig. D).
NOTE
The machine is equipped with an automatic switch that stops the water supply to the nozzles when the broom and
suction fan rotation has been stopped by pressing the switch (29, Fig. D) and the water supply has not been previously
stopped by pressing the switch (27).
41.
Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
WARNING!
In case of immediate danger for the operator or other people, press the emergency push-button to stop the
engine. Do not use the emergency push-button to stop the engine under normal conditions.
42.
The headlights must be turned off.
43.
Get out of the machine and bring the 3rd broom safety pin from the position (2, Fig. M) (disengaged) to the position (1)
(engaged), by pulling and turning the relevant lever.
INSTRUCTIONS FOR USE
RS 1300
33018312(3)2010-01
ENGLISH
27
Tabla de contenido
loading

Este manual también es adecuado para:

13300123

Tabla de contenido