Care And Cleaning - Hamilton Beach 40998 Manual De Instrucciones

Care and Cleaning

1
To avoid scale/lime deposit
buildup, empty kettle after each
use.
To remove discoloration or scale/lime deposit from heating element:
Place 1/2 teaspoon cream of tartar (available in the spice aisle of
grocery store) into the kettle. Then fill the kettle 1/2 full with water.
Plug in, turn ON (I), and bring to boil. Turn OFF (O), let cool, and
rinse several times with clean tap water.
840252200 ENv07.indd 5
2
Wipe the exterior of kettle with a
damp cloth. Do not use abrasive
scouring pads or powders since
they may scratch the smooth
surface of the kettle.
w WARNING Electrical Shock Hazard.
Do not immerse kettle, power base, or plug in water or other liquid.
If Kettle Floor Discolors: It is normal for stainless steel heating
elements to discolor. This does not affect the performance of the
kettle. Do not use abrasive scouring pads or cleaners since this
may damage the stainless steel surface.
If Kettle Boils Dry: The heating element is protected by two
automatic safety devices. If your kettle is accidentally switched on
without being filled with water, or is allowed to boil dry, the kettle
will automatically switch off. You should:
• Turn the switch to OFF (O), unplug, and wait about 20 minutes for
the element to cool down.
• Refill the kettle; then use as normal and check that the kettle
functions correctly.
If Kettle Does Not Work: Make these simple checks before calling
the toll-free customer assistance number:
• Have you turned power switch to ON (l) position?
• If the kettle heats but does not boil, it might need descaling.
• Has the kettle been switched on accidentally without being filled
with water or allowed to boil dry? Turn the switch to OFF (O), wait
20 minutes, and try again.
• Is cord firmly plugged into the outlet and kettle firmly seated in the
base?
Anti-Scale Mesh Filter: Scale is caused by lime and calcium in hard
water. The mesh filter will prevent these suspended particles from
being poured out of the kettle. The filter should be cleaned periodically
to ensure optimum performance. To clean the filter, unplug kettle and
allow to cool. The mesh filter may be removed by pulling upwards on the
tab, which is visible through the kettle opening. Rinse filter under running
water and brush with a soft brush. A small, soft-bristle brush works well.
To replace the mesh filter, slide the filter back into the slots and snap into
place. The filter will fit only one way.
5
1/15/15 10:57 AM