of the machine (see „Cleaning the
brewing unit" page 56)
The machine does not switch on
when the
button is pressed
• The main switch on the back of the
appliance is not switched on (Figure 8)
or the mains plug is not plugged in.
0 Check that the main switch is in the "I"
position and that the power lead is
plugged in the socket properly.
The brewing unit cannot be taken
out for cleaning
• The coffee machine is switched on. The
brewing unit can only be removed
when the machine is switched off.
0 Switch the appliance off and remove
the brewing unit (see „Cleaning the
brewing unit" page 56).
Attention: The brewing unit can only
3
be taken out when the appliance is
switched off using the On/Off button
at the front of the appliance. The
appliance should not be disconnected
from the mains. If you try to take out
the brewing unit whilst the coffee
machine is switched on, this could be
seriously damaged.
Coffee does not come out of the
spouts on the coffee dispenser but
out of the service door at the side
• The holes on the coffee dispenser are
blocked with dried on coffee.
0 Remove the dried on coffee with a
needle (Figure 34).
• The swing drawer (Q) on the inside of
the service hatch is blocked and will
not move.
0 Carefully clean the swing drawer, par-
ticulary in the area around the hinges
so that these continue to move.
Ground coffee was used (instead of
coffee beans) and the machine will
not dispense any coffee.
• Too much preground coffee was
inserted.
0 Remove the brewing unit and carefully
clean the insided of the machine as
described under „Cleaning the brewing
unit" page 56. Repeat the process using
a maximum of 2 level measuring
spoons of ground coffee.
• The "Coffee strength / preground cof-
fee" knob was not put into position
or
and the appliance used both
preground coffee and coffee ground by
the mill mechanism.
0 Carefully clean the inside of the
machine as described below under
„Cleaning the brewing unit" page 56.
Repeat the process, first by putting the
"Coffee strength / preground coffee"
knob in the right position as described
under „Makingcoffee with ground cof-
fee" page 47.
• Preground coffee was inserted whilst
the machine was switched off.
0 Remove the brewing unit and carefully
clean the insided of the machine as
described under „Cleaning the brewing
unit" page 56. Repeat the process with
the machine switched on.
Milk is frothed up too much or too
little
• Wrong setting of the slider on the lid
of the milk container.
0 You can set the amount of froth on the
milk to any level using the slider on the
lid (Figure 27).
– Position "1 CAPPUCCINO": very
frothy milk.
– Position "2 CAFFELATTE": not so
frothy milk.
• If the milk is not frothy enough, the
milk container may not be correctly in
place.
0 Put the milk container correctly in
place.
What should you do if the appliance
is going to be transported?
• Keep the original packaging to protect
it during transport. Always use the
original plastic bag to protect against
scratches.
g
61