Charger Wall Mount; Service And Maintenance - Festool MXC Manual De Instrucciones Original

MXC
GB
5 Technical data
Charger
Mains voltage (input)
Mains frequency
Charging voltage (output)
Rapid charging
Charging times for
LiIon 1,5 Ah
LiIon 2,6 Ah
Permitted operating tempera-
ture range
Temperature monitoring
Safety class
6 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-

er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with

the voltage specifications 120 V/60 Hz may be
used.
6.1 Charging the battery pack [1]
Charge only battery packs that are designat-
ed for use with the charger. (see Intended
use)!
The LED [1-3] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Charging battery pack at maxi-
mum rate.
LED green - flashing slowly
Charging battery pack to 80% and
with reduced current.
LED green - lit continuously
Charging process is charged.
LED red - flashing
General fault indicator, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
10
MXC
220 - 240 V ~
50/60 Hz
6.2
10.8 V=
The charger MXC has two elongated holes on its
back. It can be mounted on a wall using two screws
typ. 2.8 A
(e.g. round head or flat head screw with shank di-
ameter of 5 mm) (see Fig. [1]).
approx. 23/ min
7
approx. 45 min
Observe the following instructions:
-10 °C to + 40 °C
– Keep the air slits on the machine and the charger
via NTC-resistor
– Keep the contacts on the machine, charger and
/II
EKAT
8
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
9
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh: www.festool.com/reach
10
Charger
MXC
Year of CE mark: 2010
LED red - lit continuously
Battery temperature is outside
permissible limit values (0 °C to
55 °C).

Charger wall mount

Service and maintenance

free and clean to ensure adequate cooling.
battery pack clean.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Accessories
Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European
EU Declaration of Conformity
Serial no.
495883