GE IM6 Manual Del Propietário página 55

ICEMAKER INSTALLATION INSTRUCTIONS R
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PARTS REQUIRED THAT CAME WITH
THE REFRIGERATOR
Icemaker mounting block
Ice bucket
Part No. WR30S1 Part No. WR2M3604
PREPARE FOR INSTALLATION
1
• Remove all freezer baskets for greater accessibility
to the rear of the freezer.
• Remove and discard the
large white plug from
the rear freezer wall.
Pull out the gray
insulation plug and
remove any debris.
• Remove the outlet cover
with a flat-blade screwdriver.
Installation Instructions
Unplug the
Pliers Sharp knife
Phillips head
screws (2)
Part No. WR1M478
C F G H J K L
2 INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the
on page 66) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Go to the back of the refrigerator.
Remove the label covering the
hole. Pull out the insulation plug
and any debris.
• On the tube side of the water
tube inlet (15) there is an
adhesive backing. Remove the
adhesive backing and slide the
tube into the hole near the top at the back of the
refrigerator. Firmly press on the inlet to secure it to
the refrigerator.
3
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
4
INSTALL THE MOUNTING BLOCK
• Inside the freezer, remove the two small white plug
buttons from the side wall.
• Using the Phillips head screws
that are with the mounting
block, attach the mounting
block to the refrigerator by
driving the screws through the outer holes on
the block and into the holes that the plug buttons
were in.
• Install two self-tapping Phillips head screws (14)
from the kit in the inner holes on the mounting block.
On some models, the screws may already be in
place on the mounting block. The screw heads
should extend about 1/2" (13 mm) from the
mounting block.
54
or T
M N P Q R S
R
template
R
15
(Appearance may vary)
16
d
Hole for
wire tie