GE IM6 Manual Del Propietário página 30

INSTALL WATER LINE CLAMP
3
• Push the metal water line clamp (strain relief) (12)
onto the lower flange of the cabinet back, directly in
line with the water valve.
• The metal clamp is for the house water line. (See
the Water Line Installation Instructions). It is not
to be used for the tubing from the water valve up
to the icemaker.
4 CONNECT THE WATER LINE
• Ensure that you have sufficient length of plastic
tube to extend well into the water tube inlet.
Cut off excess tubing.
• Squeeze the ends of the hose clamp (3) from
the kit with pliers and slide the clamp over the
water tube inlet.
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1" [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water tube
inlet
Installation Instructions
12
3
29
ATTACH THE PLASTIC WATER LINE
5
Route the plastic water line along the back of the
refrigerator to the icemaker hole in the case back.
Use three of the adhesive-backed fasteners (5) to
secure the tube to the case back.
5
WATER VALVE INSTALLED
6
Refer to the Water Line Installation Instructions for
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
Adhesive-backed
fasteners for
plastic water line