Operation Start Procedure - Kamikaze KV 3 Manual De Uso

ELECTRONIC TYING MACHINE

13. OPERATION START PROCEDURE

Wear suitable cloth and glove when operate this tool. Always
check tools before use, make sure on/off switch and safe switch
are all ok. The power should be put off when you loosen the trigger.
Stop using the tool in case of switch failure. Always check rated voltage of
battery match the tying machine
Confirm the work frequency of the tying machine, and select a
suitable gear according to the conditions of usage, so as to ensure
that the tying machine is in the best state.
If front end tying mouth is blocked by a foreign matter when tying
branches, please switch off power before removing the foreign
matter.
• For the output direction of the cable and the direction of holding the tying
machine, you can decide it as for your habit, by inverting the position of
the battery in the rucksack;
• Adjust your backpack and fasten your belt.
• Connect the cable with battery tightly.
• Switch on power, the tying machine is in working state, start working
after pulling trigger.
• To save electric quantity, and ensure that the tying machine has the
longest service life, don't overload the machine; don't use it to tie
branches exceeding 25mm.
• In the process of tying, if the tying is not successful, please switch off
power. Remove the tying wire failing to tie successfully from front end
tying mouth with hand, then switch on power. Conduct idle running once
to see if it can tie successfully. If the tying becomes normal, continue
working. If the tying fails to be successful for several times, please switch
off power for inspection. Open front cover and pressing plate, check wire
at inlet and in the whole feeding track to see if there is any knotted,
accumulated, and jamming phenomenon, and clear up timely in case of
any abnormality.
73
www.kamikazevolpi.com