Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
2
► 1. Intermittent nailing 2. Continuous nailing
3. Change lever 4. Trigger lock
CAUTION:
•
Operating the tool without nails shortens the life
of the tool and should be avoided.
Air exhaust
► 1. Exhaust cover
Air exhaust direction can be changed easily by rotating
the exhaust cover. Change it when necessary.
Jammed nailer
CAUTION:
•
Always lock the trigger, disconnect the hose
and remove the nails from the magazine before
cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the door and magazine cap and remove the nail
coil. Insert a small rod or the like into the ejection port
and tap it with a hammer to drive out the nail jamming
from the ejection port. Reset the nail coil and close the
magazine cap and door.
3
4
1
7 ENGLISH
► 1. Small rod 2. Ejection port
Hook
1
► 1. Hook
The hook is convenient for hanging the tool temporarily.
This hook can be installed on either side of the tool.
CAUTION:
•
Always lock the trigger and disconnect the hose
when hanging the tool using the hook.
•
Always tighten the hook securing bolt firmly.
Loose bolt may cause air leakage from the tool.
•
Never hang the tool on a waist belt or like.
Dangerous accidental firing may result.
1
2
Tabla de contenido
