Working With The Machine; Setting Down The Planer; Service And Maintenance; Accessories - Festool EHL 65 EQ Manual De Instrucciones Original

It is possible to connect the dust extractor on
both sides of the device:
► Press the [4-5] button down firmly.
► Pull out the connecting adapter on the op­
posite side [4].
► With the button at the front, insert it into the
housing opening as far as it will go [4B]
The chip ejection can be set in any direction by
turning the angle adapter [4-3].
8

Working with the machine

WARNING
Risk of injury, damage to the spiral blade
► The surface to be planed must be free of
metals.
Wear a dust mask.
When working, guide the power tool with one
hand on the handle [4-6]. Keep your other hand
out of the hazard area.
► Set the required chip thickness (see section
7.2 ).
► Place the planer with the front of the planer
foot on the workpiece without touching the
workpiece with the planing head.
► Switch on the planer.
► Guide the planer over the workpiece so that
the planer foot lies flat on the workpiece.
▷ Apply pressure to the front of the planer
foot when starting to plane.
▷ Apply pressure to the rear of the planer
foot for the remainder of the planing
process.
8.1

Setting down the planer

WARNING
Risk of injury
► Do not use unless the support foot [1-10] is
fully functional.
► The planer shaft continues to rotate for a
few seconds after the machine is switched
off. Wait until the planer shaft stops.
A support foot [1-10] is fitted to the end of the
planer foot so that the EHL 65 EQ can be set
down safely.When the machine is lifted up, the
support foot automatically swivels over the
edge of the planer foot so that the blade does
not touch the surface when the planer is set
down.
8.2 Chamfering
The front planer foot is fitted with a 90° V
groove [1-11] for chamfering workpiece edges.
The V groove is 2 mm deep so that 2 mm of the
edge is chamfered when the planing thickness
is set to 0.
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.com/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.com/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
To clean the chip ejector:
► Remove the adapter [4-7] (if applicable).
► Empty the adapter, remove any blockages.
► Release any chips jammed in the ejector
opening [4-4], if necessary clean the ma­
chine with a resin-based solvent.
► Connect the dust extractor (section
and extract dust from the chip ejector open­
ing.

10 Accessories

The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet at "www.festool.com".
10.1 Fitting the rebate depth stop [5]
The rebate depth stop [5-2] can be adjusted in
infinite variables to a setting between 0 to 23
English
7.4 )
15