Tabla de contenido
RECTIFYING MOTOR FAULTS
PROBLEM
The motor does not start, or starts
but does not continue to run.
The motor starts but will not run at full
power.
Motor runs unevenly.
Excessively high noise.
We, ikra GmbH, Schlesierstraße 36, D-64839 Münster, Germany, declare under our sole responsibility that
the product petrol brushcutter HBTI 25, to which this declaration relates correspond to the relevant basic safety
and health requirements of Directives 2014/30/EU (EMC-Guideline), 2006/42/EC (Machinery Directive), 97/68/
EC as amended by 2011/88/EG (emmission directive, Anex IV) and 2000/14/EC (noise directive). For the relevant
implementation of the safety and health requirements mentioned in the Directives, the following standards and/or
technical specification(s) have been respected:
EN ISO 11806-1:2011; EN ISO 14982:2009; AfPS GS 2014:01
measured acoustic capacity level
guaranteed acoustic capacity level
Conformity assessment method to annexe V / Directive 2000/14/EC
The year of manufacture is printed on the nameplate and can be additionally retrieved via the consecutive serial number.
Münster, 01.01.2016
Maintenance of technical documentation: Gerhard Knorr, Kärcherstraße 57, DE-64839 Münster
POSSIBLE CAUSE
Incorrect start procedure
Incorrectly set
fuel/air mix on carburettor.
Rusted spark plug
Blocked fuel filter.
Incorrect choke lever position.
Dirty air filter
Incorrectly set
fuel/air mix on carburettor.
Incorrectly set spark gap
on spark plug.
Incorrectly set carburettor
Incorrect fuel mixture.
Incorrectly set carburettor
EC Declaration of Conformity
109,94 dB (A)
112,0
dB (A)
Gerhard Knorr, Technical Management Ikra GmbH
GB-9
REMEDIAL ACTION
Note the information in
these operating instructions.
Have the carburettor adjusted by
authorised customer service.
Clean/adjust spark plug or replace.
Replace the fuel filter.
Set the lever to RUN (operation)
Remove filter, clean and insert anew.
Have the carburettor adjusted by
authorised customer service.
Clean/adjust spark plug or replace.
Have the carburettor adjusted by
authorised customer service.
Use the correct fuel mixture (ratio 40:1)
Have the carburettor adjusted by
authorised customer service.
Tabla de contenido
