Interface; Mettler Toledo Lc-P45 Printer Settings; Pc Settings - Mettler Toledo Refracto 30P Instrucciones De Manejo

Interface

8 Interface
Using the infrared interface of the Refracto 30P, the stored measurements to-
gether with the sample identification, the measurement unit, the temperature and
the temperature-compensation coefficient can be printed out with a printer or
transferred to a PC.
An infrared adapter or a PC/printer with an IrDA interface is required.
Important
Data transfer is only possible when:
• there is visual contact between the infrared adapter and the infrared interface;
• the distance between the Refracto 30P and the infrared adapter is less than
20 cm.
8.1

METTLER TOLEDO LC-P45 printer settings

- Configure the infrared interface of the Refracto 30P as described in Chapter 5.5.
- Connect infrared adapter to printer.
- Switch printer on.
- Press the menu button on the printer.
- Set the following serial interface parameters, see the operating instructions for
the printer:
Baud rate: 9600
Parity:
Stop bits:
Data bits:
8.2

PC settings

- Configure the infrared interface of the Refracto 30P as described in Chapter 5.5.
- Connect the adapter to an available serial interface (COM1, COM2, etc.) on
the PC.
- Insert the accompanying CD-ROM into the CD-ROM drive of the PC.
- Install the MiniTerm program.
- Start the MiniTerm program on the PC.
- Select the serial interface (Port) to which the infrared adapter is connected.
- Configure additional settings according to the figure below.
- Press the OK button on the PC.
The Connect window is closed.
16
None
1
8
METTLER TOLEDO Refracto 30P