Advanced Configuration - Urrea 6205 Manual De Usuario Y Garantía

1. From Settings menu, use UP/DOWN buttons
to highlight LCD CONTRAST selection then
press ENTER button.
2. CONTRAST screen is displayed.
3. Use UP/DOWN buttons while viewing display
to change contrast to desired level.
Selectable levels: 20 to 80 in increments of 5
(factory default = 40).
4. Press ENTER button to accept selection and
exit to Settings menu.
KEY BEEP SETUP
This function will allow user to enable or dis-
able audio feedback when a button is pressed.
1. From Settings menu, use UP/DOWN buttons
to highlight KEY BEEP selection then press EN-
TER button.
2. KEY BEEP screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE
(factory default) or DISABLE selection.
4. Press ENTER button to accept selection and
exit to Settings menu.
AUTO BACKLIGHT SETUP
This function will allow user to enable or dis-
able backlight from turning on during torque
or angle measurement.
1. From Settings menu, use UP/DOWN buttons
to highlight AUTO BACKLIGHT selection then
press ENTER button.
2. AUTO BACKLIGHT screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE
(factory default) or DISABLE selection.
4. Press ENTER button to accept selection and
exit to Settings menu.
TOGGLE BACKLIGHT SETUP
This function will allow user to enable or dis-
able backlight toggle function. If toggle mode
is disabled, BACKLIGHT button turns on back-
light and it automatically turns off after five
seconds following any last button press. If
toggle mode is enabled, a BACKLIGHT button
press will turn on backlight and it will remain
on until next BACKLIGHT button press.
1. From Settings menu, use UP/DOWN buttons
to highlight TOGGLE BACKLGHT selection then
press ENTER button.
2. TOGGLE BACKLGHT screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE
or DISABLE (factory default) selection.
28
4. Press ENTER button to accept selection and
exit to Settings menu.
NOTE: Backlight will turn off when wrench
powers down either by POWER button press or
sleep time.
NOTE: If toggle backlight is enabled and back-
light is on, backlight will remain on during and
after applying torque.
VIBRATOR CONFIGURATION
This function will allow user to configure vibra-
tor for On or Off when target is reached for
preference and/or battery power savings.
1. From Settings menu, use UP/DOWN buttons
to highlight VIBRATOR CONFIG selection then
press ENTER button.
2. VIBRATOR CONFIG screen is displayed.
3. Use UP/DOWN buttons to toggle ON or OFF
selection.
4. Press ENTER button to accept selection and
exit to Settings menu.

ADVANCED CONFIGURATION

Accessing Advanced Configuration
Advanced configuration is accessed from CON-
FIGURE menu selection on main menu.
NOTE: If wrench has been locked (see Preset
Lock and Job Mode), a password entry is re-
quired to enter Configure menu.
1. From target torque or angle screen, press
and hold ENTER button for 3 seconds.
2. Highlight CONFIGURE menu selection using
UP/DOWN buttons.
3. Press ENTER button to display Configure
menu.
Menu Selections:
• EXIT: Exits Configure menu and returns to
target torque or angle screen.
• MODE SETUP: Displays wrench mode setup
menu.
• PRESET LOCK: Displays Preset lock menu.
• JOB MODE: Displays Job mode menu.
• CALIBRATION: Displays wrench calibration
menu (password protected).
• SET DATE/TIME: Displays clock date and time
entry screens.
• SET CAL INTRVAL: Displays calibration inter-
val setup screen (requires clock date and time
setup).
4. To exit Configure menu and return to target
torque or angle screen, press ENTER button
while EXIT menu selection is highlighted.