Advanced Settings - Urrea 6205 Manual De Usuario Y Garantía

ADVANCED SETTINGS

Advanced settings are accessed from SETTINGS
menu selection on main menu.
1. From target torque or angle screen, press
and hold ENTER button for 3 seconds.
2. Highlight SETTINGS menu selection using
UP/DOWN buttons.
3. Press ENTER button to display Settings menu.
MENU SELECTIONS:
• EXIT: Exits Settings menu and returns to tar-
get screen.
• SHOW INFO: Displays wrench operational in-
formation.
• SLEEP TIM: Displays power down interval
setup screen.
• LCD CONTRAST: Displays LCD contrast setup
screen.
• KEY BEEP: Displays button press beep enable/
disable setup screen.
• AUTO BACKLIGHT: Displays auto backlight
enable/disable screen to turn on backlight dur-
ing measurement.
• TOGGLE BACKLGHT:
button toggle or timeout enable /disable
screen.
• LANGUAGE: Displays the language selection
screen.
4. To exit Settings menu and return to target
torque or angle screen, press ENTER button
while EXIT menu selection is highlighted.
NOTE: All user configurable settings are stored
in non-volatile memory and are retained while
power is off.
SHOW INFO
Show Info menu selection displays wrench op-
erational information.
1. From Settings menu, press ENTER button
while SHOW INFO selection is highlighted.
2. SHOW INFO screen is displayed.
Displays BACKLIGHT
E N G L I S H •
3. UP/DOWN buttons are used to scroll screen.
Operational Information:
• SN: Serial number assigned to wrench.
• CAL: Date of last wrench calibration.
• ISD: In-Service Date.
• TCF: Torque Calibration Factor.
• ACF: Angle Calibration Factor.
• VER: Software version.
• OVR CNT: Overtorque Counter tracks how
many times an over-torque event occurred on
wrench (torque >125% of full scale).
• TQZ: Torque Zero Offset.
• ANZ: Angle Zero Offset.
4. Pressing ENTER button exits Show Info
screen and returns to Settings menu.
SETTING SLEEP TIME
This function will allow user to set interval
wrench enters power-down state following
last applied torque or button press. 1. From
Settings menu, use UP/DOWN buttons to high-
light SLEEP TIME selection then press ENTER
button.
2. SLEEP TIME screen is displayed.
3. Use UP/DOWN buttons to select sleep interval.
Selectable Intervals:
• 2 MIN (factory default)
• 5 MIN
• 10 MIN
• 30 MIN
• 1 HR
• 2 HR
• 8 HR
4. Press ENTER button to accept selection and
exit to Settings menu.
SETTING LCD CONTRAST
This function will allow user to set LCD contrast
for optimal viewing.
U se r's m a n ua l
27