Assembling The Optional Cape(Top); Assembling The Optional Cap (Bottom); Assembling The Optional Cape (Side); After The Dive - Scubapro X-Tek SIDEMOUNT SYSTEM Manual Del Usuario

Assembling the optional cape(top):

1) Secure the top cap with the j rst leash around the
shoulder strap

Assembling the optional cap (bottom):

1) Thread the lower strap of the top cap through the loop
on the back of the wing

Assembling the optional cape (side):

12. AFTER THE DIVE

Cleaning the BC, Check, Storage and Transport:
Correct servicing and maintenance guarantees you many years reliable function of your SCUBAPRO
Keep the following instructions for care:
• Fill the bladder with fresh water and shake so that the water reaches everywhere.
• Keep the bladder upside down and press the exhaust button on the ink ator so that all the water can drain.
• Disinfect the inner bladder on a regular basis to prevent bacterial growth.
• Rinse the outer shell thoroughly with fresh water.
• Clean all valves so that possible dirt is removed.
• Place a small amount of silicone on the quick release collar for the power ink ator attachement (SCUBAPRO
grease).
• Slightly ink ate the bladder and hang it up for drying. Do not dry or store the bladder in direct sunlight.
• Dry store the BC slightly ink ated in a cool dry place, protected from direct sunlight.

Inspection and Service Interval:

For your safety your BC should be inspected and maintained at an Authorized SCUBAPRO Service Center at least once
a year, more often if you dive frequently. Any damage caused due to failure to properly maintain the BC is not covered by
the warranty.

13. TRANSPORT OF THE X-TEK SYSTEMS:

Handle the XTEK systems in such a way to ensure that no sharp or heavy objects (e.g. knives, bottles, lamps, lead etc.)
damage the harness, bladder, or ink ators.
2) Repeat on the other side
2) Secure the top cap lower strap with the Velcro on it´s
inside
1) Attach the small plastic clip to the bungee that holds
your wing on the harness
® X-TEK BC.
®
silicone
15