Read This First; Safety Precautions; Ec Declaration Of Conformity - SKF THAP E Serie Instrucciones De Uso

READ THIS FIRST

Safety precautions

Read this instruction for use fully. Follow all safety
precautions to avoid personal injury or property
damage during equipment operation. SKF cannot
be responsible for damage or injury resulting from
unsafe product use, lack of maintenance or incorrect
equipment operation. In case of any uncertainties as
regards the use of the equipment contact SKF.
Failure to comply with the following could cause
equipment damage and personal injury.
• Do ensure that the equipment is only operated
by trained personnel.
• Do wear proper personal protective gear, such
as eye protection and protective gloves, when
operating the equipment.
• Do inspect the equipment and all accessories
carefully before use.
• Do not use damaged components or modify the
equipment.
• Do use clean recommended hydraulic oils
(SKF LHMF 300, LHDF 900 or similar).
Do not use glycerin or water based luids as a
•
pressure medium. Premature equipment wear
or damage can result.
• Do connect the equipment to a clean and dry air
supply.
• Do not exceed the maximum allowed 7 bar
(100 psi) air pressure.
• Do not use the equipment above the stated
maximum hydraulic pressure.
• Do not use accessories rated below the
maximum pressure of the air-driven pump or
oil injector.
• Do not use washers on sealing surfaces
• Do use a pressure gauge to monitor the oil
outlet pressure, wherever possible.
• Do ensure that all the air has been removed
from the hydraulic system before pressurising
the hydraulic system
• Do prevent the workpiece (e.g. bearing,
gearwheel or similar item) from being forcibly
ejected upon sudden release of pressure
(e.g. by use of retaining nut).
• Do not handle pressurized hoses or pressurized
high pressure pipes.
Oil under pressure can penetrate the skin,
causing serious injury. If oil is injected under the
skin, seek medical attention immediately.
• Do not use damaged hoses or damaged high
pressure pipes. Avoid sharp bends and kinks
when connecting hoses and pipes. Sharp bends
and kinks will internally damage the hose or
pipe leading to premature failure. Applying
pressure to a damaged hose or pipe may cause
it to rupture.
• Do not connect high pressure pipes to the
THAP 300E or 400E without using the
protection device supplied.
• Do not exceed the maximum torque tightening
igures given in this instruction for use.
• Do not use dirty oil hoses. The oil container can
become contaminated leading to premature
equipment wear and failure.
• Do not lift the equipment by the hoses, high
pressure pipes or couplings.
Only use the carrying handle.
• Do not leave the equipment unattended whilst
operating.
• Do follow local safety regulations
• Do service the equipment by a qualiied
hydraulic technician or SKF Repair Centre.
• Do replace worn or damaged parts with
genuine SKF parts.

EC Declaration of conformity

We, SKF Maintenance Products, Meidoornkade 14,
3992 AE Houten, The Netherlands herewith declare
under our sole responsibility that the products
described in these instructions for use, are in
accordance with the conditions of the following
Directive(s): MACHINERY DIRECTIVE 2006/42/EC
and are in conformity with the following standards:
EN-ISO 12100, EN-ISO 4413, EN-ISO 4414
Houten, The Netherlands, January 2020
Mrs. Andrea Gondová
Manager Quality and Compliance
EN 3